How To and Technical Support
- 294 Topics
- 440 Replies
We are setting up User Roles for the first time and would like to know how to bulk load leaders into each User Role based on certain attributes. Every guidance I have seen requires you to identify individuals and go in to add User Role in that profile. This manual process is not feasible for hundreds of manager roles. There must be some way to add many leaders into one User Role without going through this process, but I cannot find information on how. Thank you!
Hello can I please request access to the following sites, following a change in management recently. Individual 1 from Cocks Moors Woods to Fox Hollies Leisure Centre and Beeches Pool and Fitness Centre. ( 2 sites )Individual 2 from Fox Hollies and Stechford Leisure Centres to Cocks Moors Woods. ( 1 site)Individual 3 needs access to Stechford Leisure Centre. (1 site )
Is it possible to remove a question and its results from the dashboard/reports view? We ran a survey with a question, “I intend to leave the organization.” rather than, “I do not intend on leaving the organization.” or something else like it. Now we have results that our stakeholders are worried will be confusing during presentations, since a desirable score shows up as a low score (color-coded red), and the rest are the opposite.
Hi, we did a pulse survey recently with ~ 500 respondents. All comments are showing as suppressed. Few days back we saw that only 15%- 20% comments were suppressed and the others referred to the team they were part of. Any ideas what could have happened and how we can get comments sorted by a department or location which was part of the data upload for respondents.Thanks
Dear Team, Until yesterday, I was able to see the in-progress Team Perspectives for my team.Suddenly, today the message comes as ‘Hi Rumjhum, you don't have enough respondents to see your team's results, but you can still have a successful ACT Conversation.’Please help me understand this change.
How can i view heat map report which will show scores from at least five previous survey with the current one, at a go
Currently, when i view Heat Map report, under ‘Pulse Date’ sub section, i am able to see only the current and the last survey scores. Is it possible to increase the number of previous survey columns to get a quick comparison of the scores of all the previous surveys (at least five previous surveys, minimum). So that we could horizontally see the changes in scores of each question (either the question covered in the previous survey or not, doesn’t matter. Obviously a non repeated case would fetch no data) going from left to right to the oldest survey.
how can I participate in the Amedisys pulse survey for june 2021 if one survey has not been assigned to me?
i click on the link for the Amedisys june pulse survey, it reports that i dont have any survey assigned to me. i would like to know why are some employes excluded from the survey. Can you help me to participate ? thanks
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.